3M M1700SS Spécifications télécharger pdf (Page 32)

3M™ MicroTouch™ Display M1700SS User Guide 32

Document #19-268 Rev AL

M1700SS Display Regulatory Agency Approvals

Your product complies with the following regulatory standards:

• FCC-B

• CE

• UL/cUL

• CCC

• C-tick

• RoHS/WEEE directives

This equipment has been tested and found to comply within limits for a Class B digital

device, pursuant to Part 15 of the FCC rules. These limits are designed to provide

reasonable protection against harmful interference in residential installations. This

equipment generates, uses and can radiate radio frequency energy, and if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause interference to radio or television

equipment reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Move the equipment away from the receiver.

• Consult the dealer or an experienced radio/television technician for additional

suggestions.

CAUTION

You are cautioned that any change or modification to the equipment not expressly

approved by the party responsible for compliance could void your authority to operate

such equipment.

This Class B digital apparatus meets all requirements of the Canadian Interference-

Causing Equipment Regulations.

Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le

matériel brouilleur du Canada.

This device complies with Part 15 of the FCC rules: Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

FCC Warning

To assure continued FCC compliance, the user must use grounded power supply cord

and the provided shielded video interface cable with bonded ferrite cores. If a BNC cable

is going to be used, use only a shielded BNC(5) cable. Also, any unauthorized changes or

modifications not expressly approved by the party responsible for compliance could void

the user’s authority to operate this device.

1 2 ... 27 28 29 30 31 32 33 34 35

Pas de commentaire

3M M1700SS Spécifications Page 32